P047F Engine Trouble Code
Meaning of P047F engine trouble code is a kind of powertrain trouble code and when the check engine light comes P047F code on the first you should check is the gas cap. Pull over, retighten it, and take a look at the cap to see if it has any cracks in it. Continue driving and see if the check engine light turns off. Alternately, you can purchase a gas cap for about $3 at an auto parts store. All you need to do is take the old one off and screw on the new one. If you've already made it to the store, you might as well just replace it. While not car-threatening, it's good to take care of this right away to improve gas mileage.
P047F Fault Symptoms :
If one of these reasons for P047F code is occuring now you should check P047F repair processes.
Now don't ask yourself; What should you do with P047F code ?
The solution is here :
P047F Possible Solution:
Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.
P047F Code Meaning :
|OBD-II Diagnostic Powertrain (P) Trouble Code For Engine||Intake Valve Control Solenoid Circuit Low||O2 Sensor Heater Circuit Malfunction||Cylinder 10 Contribution/balance Fault|
The oxygen (02) sensors on your car measure the oxygen in the exhaust to determine how rich or lean the ratio of fuel and air are in the cylinders. Optimizing this mixture means better fuel economy and fewer exhaust emissions.
P047F OBD-II Diagnostic Powertrain (P) Trouble Code DescriptionP047F engine trouble code is about .
Main reason For P047F CodeThe reason of P047F OBD-II Engine Trouble Code is O2 Sensor Heater Circuit Malfunction.
P047F DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.